wtw Turb 555 Operating Manual page 50

Operation
Code function
50
In the following menu, you can activate/deactivate the code
function and change the calibration or setup code (Code is
displayed in the upper display line).
Note
When the code function is activated, all measured values
output to the printer/PC are given the "QC" (Quality Control)
identifier, provided that the calibration interval has not ex-
pired (see section 4.6.2 O
To select the code function, proceed as follows:
8
10 Press the
or off.
11 Confirm your selection with
When you have switched on the code function, the menus to
change the two codes appear (steps 12 to 21). If you want
to keep the existing codes, press
case, the next setup menu (
UTPUT OF MEASURED VALUES
2
or key to switch the code function on
1
6
p
) will appear immediately.
Turb 555 / Turb 555 IR
.
1
instead of . In this
ba41113e07
).
04/2009