wtw Turb 555 Operating Manual page 53

Turb 555 / Turb 555 IR
Setting the baud
Calibration interval
ba41113e07 04/2009
To select the baud rate proceed as follows:
rate
24 With the
Options: 1200 -> 2400 -> 4800 -> 9600
25 Confirm your selection with
In the following menu, you can select the calibration interval
(INT is displayed in the lower display line).
Note
When the calibration interval has not expired and the code
function is activated, all measured values output to the print-
er/PC are given the "QC" (Quality Control) identifier (see
section 4.6.2 O
have exceeded the calibration interval, you can continue to
measure. In this case, the measured values are output with-
out the "QC" identifier.
To set the calibration interval, proceed as follows:
8 2
or key select the required baud rate.
UTPUT OF MEASURED VALUES
1
.
). When you
Operation
53