Dynamic Radar Cruise Control With Full-Speed Range Can Be Set When; Accelerating After Setting The Vehicle Speed; When The Vehicle Stops While Follow-Up Cruising; Automatic Cancelation Of Vehicle-To-Vehicle Distance Control Mode - Toyota Camry 2018 Owner's Manual

■

Dynamic radar cruise control with full-speed range can be set when

●
The shift lever is in D or range 4 or higher of S has been selected.
●
Range 4 or higher of D has been selected by using the paddle shift switch.
(vehicles with paddle shift switches)
●
Vehicle speed is at or above approximately 30 mph (50 km/h). However,
when a preceding vehicle is detected, the dynamic radar cruise control with
full-speed range can be set even if the vehicle speed is at or below approxi-
mately 30 mph (50 km/h).
■

Accelerating after setting the vehicle speed

The vehicle can accelerate by operating the accelerator pedal. After acceler-
ating, the set speed resumes. However, during vehicle-to-vehicle distance
control mode, the vehicle speed may decrease below the set speed in order
to maintain the distance to the preceding vehicle.
■

When the vehicle stops while follow-up cruising

●
Pressing the "+ RES" switch while the vehicle ahead stops will resume fol-
low-up cruising if the vehicle ahead starts off within approximately 3 sec-
onds after the switch is pressed.
●
If the vehicle ahead starts off within 3 seconds after your vehicle stops, fol-
low-up cruising will be resumed.
■

Automatic cancelation of vehicle-to-vehicle distance control mode

Vehicle-to-vehicle distance control mode is automatically canceled in the fol-
lowing situations.
●
Actual vehicle speed falls at or below approximately 25 mph (40 km/h) when
there are no vehicles ahead.
●
The preceding vehicle leaves the lane when your vehicle is following at a
vehicle speed at or below approximately 25 mph (40 km/h). Otherwise, the
sensor can not properly detect the vehicle. ("Radar Cruise Control Unavail-
able" is displayed on the multi-information display)
●
VSC is activated.
●
TRAC is activated for a period of time.
●
When the VSC or TRAC system is turned off.
●
The sensor cannot detect correctly because it is covered in some way.
●
Pre-collision braking is activated.
●
The parking brake is operated.
●
The vehicle is stopped by system control on a steep incline.
●
The following are detected when the vehicle has been stopped by system
control:
• The driver is not wearing a seat belt.
• The driver's door is opened.
• The vehicle has been stopped for about 3 minutes
If vehicle-to-vehicle distance control mode is automatically canceled for any
other reason, there may be a malfunction in the system. Contact your Toyota
dealer.
4-5. Using the driving support systems
273
4