Table of Contents
Advertisement
218
4-2. Driving procedures
■
When the parking brake is set automatically while the system is holding
the brakes
Perform any of the following operations to release the parking brake.
●
Depress the accelerator pedal. (The parking brake will not be released auto-
matically if the seat belt is not fastened.)
●
Operate the parking brake switch with the brake pedal depressed.
Make sure that the parking brake indicator light goes off. (P. 213)
■
When an inspection at your Toyota dealer is necessary
When the brake hold standby indicator (green) does not illuminate even when
the brake hold switch is pressed with the brake hold system operating condi-
tions met, the system may be malfunctioning. Have the vehicle inspected at
your Toyota dealer.
■
Warning messages and buzzers
Warning messages and buzzers are used to indicate a system malfunction or
to inform the driver of the need for caution. If a warning message is shown on
the multi-information display, read the message and follow the instructions.
■
If the brake hold operated indicator flashes
P. 498
WARNING
■
When the vehicle is on a steep incline
When using the brake hold system on a steep incline, exercise caution. The
brake hold function may not hold the vehicle in such a situation.
■
When stopped on a slippery road
The system cannot stop the vehicle when the gripping ability of the tires has
been exceeded. Do not use the system when stopped on a slippery road.
NOTICE
■
When parking the vehicle
The brake hold system is not designed for use when parking the vehicle for
a long period of time. Turning the engine switch off while the system is hold-
ing the brake may release the brake, which would cause the vehicle to
move. When operating the engine switch, depress the brake pedal, shift the
shift lever to P and set the parking brake.
Advertisement
Table of Contents
Troubleshooting
