Operating The Homelink; Garage Door Operation Indicators; Reprogramming A Single Homelink Button - Toyota Camry 2018 Owner's Manual

Hide thumbs Also See for Camry 2018:

Table of Contents

Reprogramming a single HomeLink

When the following procedure is performed, buttons which already

have devices registered to them can be overwritten:

With one hand, press and hold the desired HomeLink

When the HomeLink

to hold the HomeLink

to start flashing).

Operating the HomeLink

Press the appropriate HomeLink

light should turn on.

The status of the opening and

closing of a garage door is shown

by the indicators.

This function is only available if the

garage door opener motor used is

a compatible device. (To check

compatibility,

www.HomeLink.com.)

Orange (flashing)

Red (flashing)

The indicators can operate within approximately 820 ft. (250 m) of

the garage door. However, if there are obstructions between the

garage door and the vehicle, such as houses and trees, feedback

signals from the garage door may not be received. To recall the pre-

vious door operation status, press and release either HomeLink

ously. The last recorded status will be displayed for 3 seconds.

indicator starts flashing orange, continue

button and perform "Programming the

(it takes 20 seconds for the HomeLink

5-4. Other interior features

button. The HomeLink

Currently opening/closing

Opening/closing has completed

Feedback signals cannot be received