idp SMART-70 User Manual page 73

Change Header: When thermal print head is replaced, the print head information must be
registered for optimal printing quality. Please change print head's serial number, resistance
value and type in the Change Head Dialog window after click "Change Head".
To show how many cards are issued with SMART-70 Printer. "Total Issue Count" is the
number of issued cards after factory shipment. "User Issue Count" is the number of issued
cards after replacing print head. When the print head is replaced, please initialize the
number by setting "Reset User Issue Count" in the Change Head Dialog window after
clicking "Change Head" of ①.
② SMART-70 Printer controls motor for the best printing quality. "RMP+", "RMP-", "RMM+"
and "RMM-" is necessary variables to control ribbon motor. Please do not adjust the
variables because the printing quality is affected.
When the normal printing speed is set, "YMC Offset", "Black Offset" and "Overlay Offset" is
added to the YMC Density, Black Density and Overlay Density and printed on card. "Ribbon
Position" is to align the panel of ribbon on the card. Please use the default setting.
③ Please refer as below for other values.
Board Type: To set the mainboard type of SMART-70 Printer. Please do not change.
Display Type: To set the LCD type of SMART-70 Printer. Please do not change.
Display Language: To select the display language on the LCD of SMART-70 Printer. Please
do not change.
Security: SMART-70 Printer provides several ways to set a security function for
authentication and access control.
PC Auth.: Printer can only be used with specific PC. To activate this option, "Set PC Serial"
is clicked to save the specific PC's information into Printer.
Physical Key: When physical key is installed into SMART-70, this option can set to activate
Printer by using the key.
User/Root Authentication: This option can set to activate Printer by using User and
Administrator (Root) password.
DCL Mode: When SDK is used to print cards with DCL mode, printer driver doesn't need
to be installed. If the DCL mode is set to "Use", printer driver is not installed on Windows.
Dump Mode: Log data can be recorded into Printer.
Card In Direction: To set the direction that card is fed.
Auto Card In: When the card is detected at card gate, the card is automatically moved
into Printer.
Card Out Direction: To set the direction that card is ejected.
73