idp SMART-70 User Manual page 50

-. First printer P0: Module ID = 0x40, Operation Mode = Master
-. Second Printer P1: Module ID = 0x41, Operation Mode = Slave
-. Hybrid Flipper H0: Module ID = 0x60
-. Laminator: Module ID = 0x50, Operation Mode = Slave
-. Output Hopper O0: Module ID = 0x70.
(2) Please connect each module by using the red SATA cables
(3) Please connect the USB Host port of the first Printer P0 with the USB Device port of the
second Printer P1 by using USB cable. Printing data is transmitted by the USB cable.
(4) Please connect the USB Host port of the first Printer P0 with the USB Device port of the
Hybrid Flipper by using USB cable. Encoding and scanning data is transmitted by the USB
cable.
(5) Please connect the USB Device port of the first Printer P0 to PC by using the USB cable or
connect Ethernet port of the first Printer P0 to network.
(6) Please connect power adaptors to all modules and turn on the power switch on all modules.
(7) Please set the combination of the system as IPPHLO by using the LCD control panel on the first
Printer.
50