idp SMART-70 User Manual page 69

① To show connected Printer.
Device: The Printer that the adjustment is needed can be selected by using the pull-down
menu. "IDP SMART-70 Card Printer" is the connected Printer's name. "SMART" is the
connected Printer's ID, "USB006" is the connected port.
Allow Network Printer: If the Allow Network Card Printer is selected, Printers connected
via network also appear in the "Device" list.
② To set administrator password and user password.
Change Root PW: To set administrator (root) password. This password is used to verify
user authority for CardPrinter70Setup and is also required as administrator password when
the User Authentication option on Security is set on advanced setup.
(When Printer is installed at the place where security is required, please set password at
the same time with the installation of Printer.)
Change User PW: To set user password for user authentication. This password is required
as user password when the User Authentication option on Security is set on advanced
setup.
③ The firmware version, serial number of Printer, serial number of TPH, resistance value of
TPH, type of TPH is shown.
④ The printing area on card is shown. It shows exaggeratingly for user convenience and is not
real position.
⑤ To set the printing area on card. Please set it properly to print on an entire card because
SMART-70 is a direct thermal card printer. When you click "⑦ Print", a card is printed as
like "④ example". Please set values properly that all circles of each corner are printed and
blank spaces are narrower than 0.5mm on the top and the bottom of a card. Please set
values by following order.
X Start Position: Please set the right and the left of printing position on card properly by
adjusting X position.
Y Start Position: Please set the start position of printed example image and blank space in
the top is 0.4mm ~ 0.5mm.
69