idp SMART-70 User Manual page 19

>>OverlayDensity
>Operation
>>Ribbon Balance
>>Network Mask
>Information
>>Factory Count
>>YScale
>>TotalDensity
>>ColorDensity
>>BlackDensity
>>RMP+
>>RMP-
>>RMM+
>>RMM-
>>HeadResister
>>Print Sample
>>Printer Serial
>>Firmware Ver.
>>Head Serial
>>IP Address
>>Gateway
>>MAC Address
>>User Count
To set the length of printed image on the card's Y-
axis.
To set the total printing density.
To set the color density
To set the resin black density.
To set overlay density.
To adjust the force for pulling print ribbon during
printing when the residual quantity of print ribbon is
in its maximum quantity.
To adjust the force for pulling print ribbon during
printing when the residual quantity of print ribbon is
in its minimum quantity.
To adjust the force for pulling print ribbon during
alignment when the residual quantity of print ribbon
is in its maximum quantity.
To adjust the force for pulling print ribbon during
alignment when the residual quantity of print ribbon
is in its minimum quantity.
To set resistance value of TPH (Thermal Print Head).
To print a sample card.
To show the serial number of Printer.
To show the firmware version of Printer.
To show the serial number of TPH.
To show the print ribbon type and balance.
To show the current IP address of Printer.
To show the current Network mask of Printer.
To show the current Gateway of Printer.
To show the MAC address of Printer.
To show the number of issued cards that user can
reset.
To show the number of accumulated issued cards
after factory shipment.
19