Omron NJ501 series Connection Manual page 22

Nj-series;nx-series
Hide thumbs Also See for NJ501 series:
Table of Contents

Advertisement

6
The dialog box on the right is
displayed. Check the contents
and click OK.
*The contents of the dialog box
vary depending on the status of
Controller. Check the contents
and click on an appropriate
button to proceed with the
processing.
7
The dialog box on the right is
displayed. Check the contents
and click OK.
8
The Auto Connect Project
Dialog Box is displayed online.
When an online connection is
established, a yellow bar is
displayed under the toolbar.
The following panes are
displayed in this window.
Left: Multiview Explorer
Top right: Toolbox
Bottom right: Controller Status Pane
Top middle: Edit Pane
The following tabs are displayed
in the bottom middle of this
window.
Output Tab Page
Build Tab Page
Additional Information
For details on the online connections to the Controller, refer to Section 6. Online Connections
to a Controller of the Sysmac Studio Version 1 Operation Manual (Cat. No. W504).
9
Double-click EtherCAT under
Configurations and Setup in
the Multiview Explorer.
7.EtherCAT Connection Procedure
Multiview
Edit Pane
Explorer
Output Tab
Build Tab
Page
Page
Toolbox
Controller
status
Pane
19

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nj301 seriesNx701 seriesNj101 seriesNx1p2 series

Table of Contents