Autosampler Operation
Rinse Beakers – Press the ▲ / ▼ keys to highlight Rinse Beakers and press the
•
f2 (select) key . Press the ▲ / ▼ keys to highlight 0, 1, 2 or 3 as the number
of the rinse beakers that will be used on the autosampler and press the
f2 (accept) key .
Rinse Time – Press the ▲ / ▼ keys to highlight Rinse Time and press the
•
f2 (select) key . Use the numeric keypad to enter the time (in seconds) that
the electrodes will be rinsed in each rinse beaker and press the f2 (accept)
key . The rinse time can be set from 1 to 59 seconds .
Stirrer Speed – Press the ▲ / ▼ keys to highlight Stirrer Speed and press the
•
f2 (select) key . Press the ▲ / ▼ keys to highlight Off, 1, 2, 3, 4 or 5 as the
stirrer speed of the stirrer probe and press the f2 (accept) key .
Samples – Press the ▲ / ▼ keys to highlight Samples and press the
•
f2 (select) key .
•
To enter the number of samples that will be run on the autosampler, press
the ▲ / ▼ keys to highlight Number of Samples and press the f2 (accept)
key . Use the numeric keypad to enter the number of samples and press
the f2 (accept) key .
To set the sample ID, press the ▲ / ▼ keys to highlight Sample ID and
•
press the f2 (accept) key . Press the ▲ / ▼ keys to highlight Off, Manual
or Auto Incremental and press the f2 (accept) key . If Auto Incremental is
selected, use the alphanumeric keypad to enter the initial sample ID and
then press the f2 (accept) key . Refer to the meter pullout guide for the
location of the letter keys on the numeric keypad . The meter will save the
entered sample ID and add a sequential number after it .
•
Once all of the sample settings are entered, press the f1 (back) key .
Once all of the autosampler settings are entered, press the f1 (back) key .
•
Thermo Scientific Orion DUAL STAR
pH/ISE Meter User Guide
™