Thermo Scientific Orion DUAL STAR User Manual page 32

Meter Setup
Alarm
Press the ▲ / ▼ keys to highlight Alarm and press the f2 (select) key . View and
change the alarm settings, if required .
Alarm – Press the ▲ / ▼ keys to highlight Alarm and press the f2 (select)
•
key . Press the ▲ / ▼ keys to highlight Off, Low Limit, High Limit or Both Low/
High and press the f2 (select) key .
Parameter – Press the ▲ / ▼ keys to highlight Parameter and press the
•
f2 (select) key . Press the ▲ / ▼ keys to highlight pH, ISE-ppm, ISE-mg/L,
ISE-%, ISE-M, ISE-unitless, mV, RmV, ORP or °C (°F will be shown instead of °C
if it is the selected temperature unit) and press the f2 (accept) key .
Low Limit – Press the ▲ / ▼ keys to highlight Low Limit and press the
•
f2 (select) key . To enter a low limit alarm value, use the numeric keypad
and decimal key to enter the low value and press the f2 (accept) key .
High Limit – Press the ▲ / ▼ keys to highlight High Limit and press the
•
f2 (select) key . To enter a high limit alarm value, use the numeric keypad
and decimal key to enter the high value and press the f2 (accept) key .
Note: The read type must be set to continuous to use the alarm settings.
Sample D
Press the ▲ / ▼ keys to highlight Sample ID and press the f2 (select) key .
Press the ▲ / ▼ keys to highlight Off, Manual or Auto Incremental and press the
f2 (accept) key . If Auto Incremental is selected, use the alphanumeric keypad
to enter the initial sample ID and press the f2 (accept) key . The meter will
save the entered sample ID and add a sequential number after it .
Method
Press the ▲ / ▼ keys to highlight Method and press the f2 (select) key . Press
the ▲ / ▼ keys to highlight the desired method number, press the f2 (load)
key and press the f2 (yes) key . To view a method, edit a method, copy an
existing method to a new method, delete a method, print a method or save the
current meter settings as a new method, refer to Chapter 5 Methods .

Thermo Scientific Orion DUAL STAR pH/ISE Meter User Guide
™