Thermo Scientific Orion DUAL STAR User Manual page 37

Calendar
Press the ▲ / ▼ keys to highlight Calendar and press the f2 (select) key . View
and change the Time, Date and Date Format settings, if required .
Time – Press the ▲ / ▼ keys to highlight Time and press the f2 (select)
•
key . Use the numeric keypad to set the time in 24 hour format and press
the f2 (accept) key .
Date – Press the ▲ / ▼ keys to highlight Date and press the f2 (select)
•
key . Use the numeric keypad to set the date (the date format is shown
below the date setting) and press the f2 (accept) key .
• Date Format – Press the ▲ / ▼ keys to highlight Date Format and press
the f2 (select) key . Press the ▲ / ▼ keys to highlight MM/DD/YYYY to
display the date as month/day/year or DD/MM/YYYY to display the date as
day/month/year and press the f2 (accept) key .
Once all of the date settings are entered, press the f1 (back) key .
•
Troubleshooting
Press the ▲ / ▼ keys to highlight Troubleshooting and press the f2 (select) key
to access the stability test, self test, user reset, factory configuration or general
meter information . Refer to the Troubleshooting Guide section for details .
Stability Test – Press the ▲ / ▼ keys to highlight Stability Test and press the
•
f2 (accept) key . Press the ▲ / ▼ keys to highlight Channel 1 or Channel 2
and press the f2 (accept) key . Make sure that the electrode or probe to be
tested is connected to the channel that was selected in the previous step
and press the f2 (yes) key . Place the electrode or probe in an appropriate
solution with a stable temperature (a pH 7 buffer is recommended for a pH
electrode, a calibration standard with a moderate concentration of the ion of
interest is recommended for an ISE and an ORP standard is recommended
for an ORP electrode) and press the f2 (yes) key . The meter will perform
the stability test and show the mV per minute drift and noise on the display .
Press the f1 (escape) key to return to the measurement mode .
Thermo Scientific Orion DUAL STAR pH/ISE Meter User Guide
™
Meter Setup