Network Connection; Default Ip Address - Illustra Flex Quick Start Manual

3mp indoor and outdoor dome cameras

Table of Contents

Since this is a network-based unit, an IP address must be assigned at the very first bootup. The

default IP address of the unit is 192.168.1.168 and sub mask is 255.255.255.0.

However, if you have a DHCP server in your network, the unit obtains an IP address automatically

from the DHCP server so that you do not need to change the IP address of the camera.

Note:If you assign the camera a Static IP address prior to DHCP being enabled, the camera first

reboots for approximately 30 seconds and then remains accessible at its Static IP until it connects to

a DHCP server.

• Connect to a PC directly: Directly connect the camera to a PC using a standard Ethernet

cable.

• Connecting a camera to a Local Area Network (LAN): To add the camera to an existing

LAN, connect the camera to the hub or switch on your network. If you want to provide the

camera power using the Ethernet connection, a PoE-enabled hub or switch is required.

Default camera settings

The following table describes the default camera settings.

Illustra Flex 3MP Indoor and Outdoor Dome Cameras Quick Start Guide

Network Connection

Figure 26 Network connection diagram

Network Settings

DHCP

Static IP Address

Default Username

Default Password

Defaults

Enabled

192.168.1.168

admin

8200-1456-02 E0

Table of Contents