Table of Contents
Advertisement
a
Connect the RJ-45 jack to a PoE compatible network device that supplies power
through the Ethernet cable.
Note:The power source needs to be NEC Class 2 or LPS. The PoE connection should be provided
by a UL Listed product and the connections shall be made in accordance with Article 800 of the NEC
or local regulations.
Procedure 8 Mounting the camera
Step Action
1
Mark holes that correspond to the camera base on the mounting surface
2
Drill holes.
3
Fasten the anchors to the mounting surface with screws.
4
Connect the Safety Wire (fall prevention wire, not supplied) with one end to the ceiling and
the other to the safety-cord screw of the unit.
5
Secure the unit bottom case to the wall or ceiling with tapping screws.
6
Adjust the viewing angle.
Depending on the material of your mounting surface, you may require different screws and
anchors than those as supplied. To prevent the unit from falling off, ensure that it is secured to a
WARNING
firm place (ceiling slab or channel) with a safety wire (not supplied) strong enough to sustain the
total weight of the unit. Pay also attention to the finishing at the end of the wire. Never turn the lens
more than 360°, which should disconnect or break internal cables.
Safety wire must be connected with one end to the ceiling and the other to the safety-cord screw of
CAUTION
the unit.
Procedure 9 Optional - 4S Electrical Junction Box
Step Action
1
Secure the mounting kit (optional) to 4S Electrical box using 2 appropriate screws.
2
Secure the unit case to mounting kit using 2 appropriate screws.
3
Tuck the cables in the 4S Electrical box.
4
Adjust the view angles.
5
Attach the unit housing.
6
Turn the power on after you install the unit.
15
Illustra Flex 3MP Indoor and Outdoor Dome Cameras Quick Start Guide
- End -
- End -
8200-1456-02 E0
Advertisement
Table of Contents
