Power Supply; Setting Mode; Function Setting - Jadever JCN User Manual

4-3 Power Supply

Power supply
Please verify the local power source before plugging into the power outlet, and use the
individual power socket and original adaptor.
Alternative power supply
1)（9V/400mA）adaptor
2) (6V/4A) internal rechargeable battery
Power Consumption
About 300mW (without backlight)
About 380 mW (with backlight)
Low battery warning
When ― ‖ appears in the upper left corner of the weight window, the battery power requires
recharging. The charge lamp turns green from red when the recharging is completed (which
takes about 8 hours). Disconnect the scale from power supply when it is fully charged. A full
charged battery can operate the scale for approximately 65 hrs with backlight, 80hrs without
backlight.
Note: Battery is to be
occur if replaced with the wrong type or connected improperly

5. Setting Mode

5-1 Function Setting

G N/SET
1) Press
G N/SET
Or long press

/MR
2) Press key
G N/SET
3) Press key

/MR
4) Press key
M+/SAVE
5) Press key
ZERO/ESC
Press key
ZERO/ESC
6) Press key
Note: In the parameter setting mode, press the numeric key to choose the parameter
directly.
replaced only by an authorized service dealer .Risk of explosion can
key while powering on
key in the weighing mode to enter parameter setting.

TARE/
or to circle the parameters
to enter the selected parameter.

TARE/
or to circle the items of present parameter.
to save after changing and return to parameters choosing. While
to return without saving.
again to return to weighing mode.
5