Cn Ser And - Panasonic minas a series Operating Manual

CN SER and CN NET Connectors (For PC or Controller)
• These connectors can be used as either RS232C or RS485. There are three ways for using
these connectors as shown below.
For RS232C communication only
Connect the personal computer and the driver 1:1 through RS-232C,The PANATERM using for
communication control softwere. The PANATERM using this function the monitor of the personal
computre settings wave graphics.
How to connect
ID MODE SET
IM SP
I/F
Rotary switch (ID): default position of 1 must be selected
For both RS232C and RS485 communication
You connect the host and the 1st driver with RS232C, and connect the drivers in series with
RS485.
ID MODE SET
IM SP G
I/F
Rotary switch (ID): select a position 1 to F.
For RS485 communication only
Connect all the drivers and a host with RS485.
• Rotary switch (ID): select a position 1 to F.
< NOTE >
• Max. 15 drivers can be connected to a host.
• For detailed information, see Communication Specifications.
Special
cable (optional)
G
CN SER
RS485
ID MODE SET
IM SP
RS485 connector
(CN NET)
R S 2 3 2 C c o n n e c t o r
(rear)
RS485
ID MODE SET
G IM SP
I/F I/F
- 27 -
Turn off the power of both the
driver and computer, before con-
necting or disconnecting the con-
nectors.
Tighten the screws firmly.
Host (personal computer or
controller)
G
RS232C
232C/485 connector
(CN SER)
Rotary switch (ID):
select the position of 0.