Panasonic minas a series Operating Manual page 16

Mounting Direction and Space Requirements
• Allow enough space to ensure enough cooling.
• Install fans to provide a uniform distribution of temperature in the control box.
• Observe the environmental requirements for the control box, mentioned in the previous
page.
ID MODE SET
IM SP G
I/F
min.
40mm
SIG
U
V
W
< Notes >
Conformance to UL Standard
Observing the following instruction makes this driver a UL508C standard authorized and EN50178
approved product.
1 Instructions in wiring
1 ) U s e c o p p e r c o n d u c t o r w i r e w i t h t h e r a t e d t e m p e r a t u r e o f 6 0 Å é o r h i g h e r f o r
wiring to terminal blocks or grounding terminals.
2)Be sure to connect the protective grounding of the control panel(PE) to a protective
grounding terminal(
the protective grounding terminals (
2 Overload protection level
The overload protective function of the driver is activated when the ef fective current
o f t h e d r i v e r i s 11 5 % o r m o r e o f t h e r a t e d c u r r e n t . M a k e s u r e t h a t t h e e f f e c t i v e
current of the driver dose not exceed the rated current. The maximum allowable instantaneous current of
the driver is the current set by the torque limit setting(Pr06).
3 Installation environment
Use the driver in environment with the pollution level 2 higher provided in IEC60664-1.For
example,installing in a control panel of IP54 makes the pollution level of the environment 2. To achieve
IP54,the structure shall not allow water,oil,carbon or dust to enter.
Fan
ID MODE SET
IM SP G
I/F
min. min.
10mm 10mm
SIG
U
V
W
) of the driver to prevent electric shock. Do not double-connect to
).Two protective grounding terminals are provided.
- 15 -
Fan
ID MODE SET ID MODE
IM SP G IM SP
I/F
min.
10mm
SIG
U
V
W
min.
100mm
SET
G
I/F
min.
40mm
SIG
U
V
W
min.
100mm