Table of Contents
Advertisement
Chapter 38 Troubleshooting
The ALM LED is on.
Turn the X2002 off and on.
1
Disconnect and re-connect the power adaptor to the X2002.
2
If the problem continues, contact the vendor.
3
One of the LEDs does not behave as expected.
Make sure you understand the normal behavior of the LED. See
1
page
32.
Check the hardware connections. See the Quick Start Guide.
2
Inspect your cables for damage. Contact the vendor to replace any damaged
3
cables.
Disconnect and re-connect the power adaptor to the X2002.
4
Turn the X2002 off and on.
5
If the problem continues, contact the vendor.
6
38.2 X2002 Access and Login
I forgot the IP address for the X2002
The default LAN IP address is 192.168.1.12.
1
Use the console port to log into the X2002 (see
2
Use the command "network interface show ip all" to check the WAN and LAN
3
IP addresses of the X2002.
Enter the initrd screens and change the X2002's IP address to the WAN/LAN
4
default (see
490
Section 38.6.3 on page
Section 38.6 on page
497).
Section 1.4 on
496.
X2002 User's Guide
Advertisement
Table of Contents
