Table of Contents
Advertisement
The following table describes the labels in this screen.
Table 173 WWW > Add/Edit
LABEL
Access
Interface
Address Type
Apply
Cancel
32.3 The SSH Screen
You can use SSH to access the X2002's command line interface. Specify which
interfaces allow SSH access and from which IP address the access can come. Click
Advanced > Remote Management > SSH tab to display the screen as shown.
Figure 255
The following table describes the labels in this screen.
Table 174 Remote Management > SSH
LABEL
Activate SSH
Remote
Management
White List
#
Access
Interface
X2002 User's Guide
DESCRIPTION
Select the interface(s) through which computer(s) may access the
X2002 using this service. Select ALL to allow the specified computer(s)
to access the X2002 through either LAN or WAN interface.
Select ALL to allow any computers to access the X2002 using this
service.
Select Host and specify the IP address of a trusted computer to allow
the computer to access the X2002 using this service.
Select Subnet and specify the IP addresses of a trusted subnet to allow
all computers from the subnet network to access the X2002 using this
service.
Click this to save your changes and to apply them to the X2002.
Click this to begin configuring the fields again.
Remote Management > SSH
DESCRIPTION
Select this to allow only computers which use IP addresses listed in this
screen to access your X2002 via an SSH connection.
This field displays the index number of records in this table.
This field displays the interface(s) through which a computer may access
the X2002 using this service.
Chapter 32 Remote Management
431
Advertisement
Table of Contents
