Table of Contents
Advertisement
Chapter 18 Outbound Line Group
Each field is described in the following table.
Table 86 Add/Edit FXO Trunk
LABEL
Machine ID
Group Name
Description
Apply
Back to
Outbound
Group/Cancel
18.2.2 Configure an FXO Trunk
Use this screen to configure an FXO Trunk. Click the Advanced icon in the FXO
Trunk section of the Outbound Line Group configuration screen to view the
screen as shown.
Figure 143 Configure an FXO Trunk
Each field is described in the following table.
Table 87 Configure an FXO Trunk
LABEL
Available
Interface
Used Interface
260
DESCRIPTION
Select the ID of the X2002 on which you want to configure the FXO
interface. This is an internal name (not configurable) of the X2002.
This field is not available when editing an FXO configuration.
Type the name of this FXO interface. This field can be 1-20
alphanumeric charactrers (A-Z, a-z, 0-9) and underscores (_).
Type the description for this FXO interface. This field can be 0-63
alphanumeric characters (A-Z, a-z, 0-9), underscores (_), hyphens (-)
and spaces. 0 means this field can be left blank.
Click Apply to save your changes.
Click this to go to the Outbound Line Group screen without saving
your changes.
DESCRIPTION
This column displays the FXO ports available on the X2002. Highlight
one of the FXO ports and click the Right icon if you want to add it to
this outbound line group.
This column displays the FXO ports currently configured for this
outbound line group. Highlight one of the FXO ports and click the Left
icon if you want to remove it from the outbound line group.
If you configure more than one interfaces in this outbound line group,
the X2002 check and pick one of them available for an outgoing call.
X2002 User's Guide
Advertisement
Table of Contents
