Toshiba TOSVERT VF-nC3 Instruction Manual page 54

(3) Coast stop
Assign parameters as described below in case of
Coast stop. Inverter will display off at Coast stop.
1) Assign "6 (ST)" to an input terminal. Set parameter
=. Open the ST-CC for coast stop(see the
status described on the right).
2) Assign "96 (FRR)" to an input terminal.
Coast stop is done by shorting FRR and CC.
3
3.2.2
[Example of  setting procedure] fmod=0: Setting the frequency by the terminal VI
Panel operation
MODE
* Pressing the MODE key twice returns the display to standard monitor mode (displaying output frequency).
(1) Setting using the keypad or extension panel option (= or )
For an extension panel option,
 Example of operating from the panel (=: press in center to save)
Panel operation
How to set the frequency
LED display
Displays the output frequency (operation stopped).

(When standard monitor display selection = [Output frequency])
Displays the first basic parameter [History ()].

Turn the setting dial, and select "".

Press the center of the setting dial to read the parameter value.

(Standard default: ).
Turn the setting dial to change the parameter value to  (terminal VI).

The parameter value is written. and the parameter value are

displayed alternately several times.
: Moves the frequency up
LED display



Motor
speed
F-CC
ST-CC
Operation
: Moves the frequency down
key moves the frequency up,
Displays the output frequency.
(When standard monitor display selection = [Output frequency])
Set the frequency command value. (The frequency will not be saved
if the power is turned off in this state.)
Save the frequency command value.  and the frequency are
displayed alternately.
C-6
E6581595
Coast stop
key moves the frequency down.
Operation
ON
OFF
ON
OFF