The Firewall Rule Screen - ZyXEL Communications P-793H v3 User Manual

10.3 The Firewall Rule Screen

Note: The ordering of your rules is very important as rules are applied in turn.
Refer to Section 10.5 on page 110
Click Security > Firewall > Rules to bring up the following screen. This screen displays a list of
the configured firewall rules. Note the order in which the rules are listed.
Figure 61 Security > Firewall > Rules
The following table describes the labels in this screen.
Table 36 Security > Firewall > Rules
LABEL
Packet
Direction
Create a new
rule after rule
number
#
Active
Source IP
Destination IP
Service
Action
Schedule
Chapter 10 Firewalls
for more information.
DESCRIPTION
Use the drop-down list box to select a direction of travel of packets for which you
want to configure firewall rules.
Select an index number and click Add to add a new firewall rule after the selected
index number. For example, if you select "6", your new rule becomes number 7 and
the previous rule 7 (if there is one) becomes rule 8.
The following read-only fields summarize the rules you have created that apply to
traffic traveling in the selected packet direction. The firewall rules that you
configure (summarized below) take priority over the general firewall action settings
in the General screen.
This is your firewall rule number. The ordering of your rules is important as rules
are applied in turn.
This field displays whether a firewall is turned on or not. Select the check box to
enable the rule. Clear the check box to disable the rule.
This drop-down list box displays the source addresses or ranges of addresses to
which this firewall rule applies. Please note that a blank source or destination
address is equivalent to Any.
This drop-down list box displays the destination addresses or ranges of addresses
to which this firewall rule applies. Please note that a blank source or destination
address is equivalent to Any.
This drop-down list box displays the services to which this firewall rule applies. See
Appendix F on page 279 for more information.
This field displays whether the firewall silently discards packets (Drop), discards
packets and sends a TCP reset packet or an ICMP destination-unreachable message
to the sender (Reject) or allows the passage of packets (Permit).
This field tells you whether a schedule is specified (Yes) or not (No).
P-79X Series User's Guide
104