E) -Idto; F) -Eod; G) -H450 - Planet Networking & Communication VIP-101T Command Line Interface Manual

PLANET VIP-101T CLI configuration
Default
2 (H.245 signal type)
G
It is not suggested to change this parameter without assistance of your VoIP or PBX
Note
system administrator.
e) –idto
Parameter –idto is used to setup the interval (in second) of two pressed digits, iff there
is no action in this duration, VIP-101T will dial out the pressed numbers.
Syntax Description
-idto Interval between dial string Digits.
Default
5 seconds
f) –eod
Terminal digit selection, once this specified digit is pressed on the keypad, VIP-101T will
send out the dialed digits.
Syntax Description
–eod 0/1/2/3 (0 for no end of dial key , 1 for "OK" button , 2 for "#" button , 3 for
"＊" button )
Default
#

g) -h450

Parameter –h450 can be used to enable or disable the H.450 features supported in
VIP-101T. H.450 service supported: call transfer, call on hold and call forward.
Syntax Description
-h450 Enable or disable H.450 related features.
Default
1 (H.450 service is turned on)
- 19 -