C) -Callalive; D) -Keypad - Planet Networking & Communication VIP-101T Command Line Interface Manual

PLANET VIP-101T CLI configuration
Parameter –plan is used to setup dialstring length. While the number (E.164 number in
phone book) you dialed is 7 digits, this parameter should be configured as 7 or 0.
Syntax Description
-plan dial string length ( number 1 ~ 24 to limit the dialed digits, 0 for unlimited, but
Max. dialed digits is 24. )
Default
0 (not limited, Max. allowed dialed digits count is 24.)
1. If this parameter is set to 0, this will disable length checking in phone book (Max.
dialed digits is 24), and dialing string between 1-24 digits can be set.
G
2. By default settings, symbol "#" is used to send out the dial-string. If you don't wish
Hint
to wait the dialed digit interval timeout, you may press "#" key to send out numbers
to desired destinations.
c) –callalive
VIP-101T is able to check if there are network activities during calling process.
Parameter –callalive can enable or disable auto-disconnect operation after 10 seconds
not receiving packets from remote calling party
Syntax Description
-callalive Enable or disable auto-disconnection after 10 seconds not receiving
packets from remote party. 0 for disable and 1 for enable
Default
0
d) –keypad
Parameter –keypad is used to setup DTMF transmission method. You may select DTMF
type in VIP-101T for DTMF receiving and transmitting activities.
Syntax Description
–keypad
0/1/2/3 (0 for inband ,1 for H.245 alphanumeric, 2 for H.245 signal type, 3 for
Q.931 user info, 4 for RFC2833.)
- 18 -