A) -Print; B) -Add - Planet Networking & Communication VIP-101T Command Line Interface Manual

PLANET VIP-101T CLI configuration
a) –print
Parameter print can be used to display phone book database information. You can display
all data in phone book by adding –print parameter. Furthermore, you like to display a section
of data, indication parameter 'start_record' and 'end_record' can be used (pbook –print
"start index #" "end index #"). If parameter 'end_record' is omitted, only record
'start_record' will be display (pbook –print "start index #").
Syntax Description
-print [start index #] [end index #]
Default
This command has no default value.
Example
usr/config$ pbook -print
index Name
====================================================================
1 test1
2 test2
-----------------------------------------------------------------
usr/config$ pbook -print 1 1
index Name
===================================================================
1 test1
-------------------------------------------------------------------
usr/config$ pbook -print 1 2
index Name
===================================================================
1 test1
2 test2
--------------------------------------------------------------------

b) -add

Parameter add is used to create a new entry in phone book table by give a name and e164
number for the Gateway / Terminal IP address.
Syntax Description
–add name "X" ip "xxx.xxx.xxx.xxx" e164 "X")
Default
Display phonebook data.
IP
210.66.155.90
vip.planet.com.tw
IP
210.66.155.90
IP
210.66.155.90
vip.planet.com.tw
E164
5555
0
E164
5555
E164
5555
0
- 11 -