Sntp; Sntp Settings - D-Link xStack DES-3200 Series Reference Manual

The fields that can be configured are described below:
Parameter
SMTP State
SMTP Server
Address
SMTP Server Port
(1-65535)
Self Mail Address
Add A Mail Receiver
Subject
Content
Click the Apply button to accept the changes made for each individual section.
Click the Add button to add an entry.

SNTP

The Simple Network Time Protocol (SNTP) is a protocol for synchronizing computer clocks through the Internet. It
provides comprehensive mechanisms to access national time and frequency dissemination services, organize the
SNTP subnet of servers and clients, and adjust the system clock in each participant.

SNTP Settings

Users can configure the time settings for the Switch.
xStack® DES-3200 Series Layer 2 Managed Fast Ethernet Switch
Figure 9-11 SMTP Settings window
Description
Use the radio button to enable or disable the SMTP service on this device.
Enter the IP address of the SMTP server on a remote device. This will be the device
that sends out the mail for you.
Enter the virtual port number that the Switch will connect with on the SMTP server. The
common port number for SMTP is 25, yet a value between 1 and 65535 can be
chosen.
Enter the e-mail address from which mail messages will be sent. This address will be
the "from" address on the e-mail message sent to a recipient. Only one self-mail
address can be configured for this Switch. This string can be no more that 64
alphanumeric characters.
Enter an e-mail address and click the Add button. Up to eight e-mail addresses can be
added per Switch. To delete these addresses from the Switch, click the corresponding
Delete button in the SMTP Mail Receiver Address table at the bottom of the window.
Enter the title of the testing mail.
Enter the content of the testing mail.
235