Chapter 3 Management; Arp; Static Arp Settings; Arp Table - D-Link xStack DES-3200 Series Reference Manual

Chapter 3

ARP

Gratuitous ARP
IPv6 Neighbor Settings
IP Interface
Management Settings
Session Table
Single IP Management
SNMP Settings
Telnet Settings
Web Settings
ARP

Static ARP Settings

The Address Resolution Protocol is a TCP/IP protocol that converts IP addresses into physical addresses. This
table allows network managers to view, define, modify, and delete ARP information for specific devices. Static
entries can be defined in the ARP table. When static entries are defined, a permanent entry is entered and is used
to translate IP addresses to MAC addresses.
To view the following window, click Management > ARP > Static ARP Settings, as show below:
The fields that can be configured are described below:
Parameter
ARP Aging Time (0-65535)
IP Address
MAC Address
Click the Apply button to accept the changes made for each individual section.
Click the Delete All button to remove all the entries listed.
Click the Edit button to re-configure the specific entry.
Click the Delete button to remove the specific entry.

ARP Table

Users can display current ARP entries on the Switch.
To view the following window, click Management > ARP > ARP Table, as show below:
xStack® DES-3200 Series Layer 2 Managed Fast Ethernet Switch
Management
Figure 3-1 Static ARP Settings window
Description
The ARP entry age-out time, in minutes. The default is 20 minutes.
The IP address of the ARP entry.
The MAC address of the ARP entry.
22