Table of Contents
Advertisement
Rear Panel
IAD-200
IAD-200W
ADSL port
PSTN
Phone
LAN
Reset Button
(Reset to Defaults)
Power switch
Power port
Figure 3: Rear Panel
Connect this port to your ADSL line.
Connect this to your PSTN line (normal analog phone line).
Connect a standard phone here.
Connect this port to your hub, using the supplied LAN cable.
This button will reset the IAD-200 / IAD-200W to the factory default
settings.
To do this, press and hold the Reset Button for five (5) seconds, until
the Status LED is lit, then release the Reset Button, and wait the
IAD-200 / IAD-200W to restart using the factory default values.
Press IN for power ON, OUT for power OFF.
Connect the supplied power adapter here.
7
Advertisement
Table of Contents
