Table of Contents
Advertisement
If you cannot connect
If the IAD-200 / IAD-200W does not respond, check the following:
•
The IAD-200 / IAD-200W is properly installed, LAN connection is OK, and it
is powered ON. You can test the connection by using the "Ping" command:
•
Open the MS-DOS window or command prompt window.
•
Enter the command:
ping 192.168.0.1
If no response is received, either the connection is not working, or your
PC's IP address is not compatible with the IAD-200 / IAD-200W's IP Ad-
dress. (See next item.)
•
If your PC is using a fixed IP Address, its IP Address must be within the range
192.168.0.2 to 192.168.0.254 to be compatible with the IAD-200 / IAD-
200W's default IP Address of 192.168.0.1. Also, the Network Mask must be set
to 255.255.255.0. See Chapter 4 - PC Configuration for details on checking
your PC's TCP/IP settings.
•
Ensure that your PC and the IAD-200 / IAD-200W are on the same network
segment. (If you don't have a router, this must be the case.)
•
Ensure you are using the wired LAN interface. The Wireless interface can only
be used if its configuration matches your PC's wireless settings.
Setup Wizard
The first time you connect to the IAD-200 / IAD-200W, you should run the Setup Wizard to
configure the IAD-200 / IAD-200W for Internet access.
1. Select Setup Wizard on the main menu.
2. Step through the Wizard until finished.
•
You need the data supplied by your ISP. Most connection methods require some data
input.
•
The common connection types are explained in the following table.
3. On the final screen of the Wizard, run the test and check that an Internet connection can be
established.
4. If the connection test fails:
•
Check all connections, and the front panel LEDs.
•
Check that you have entered all data correctly.
12
Advertisement
Table of Contents
