2.1.3 Rear Panel of VDR-301N
The rear panel provides the physical connectors connected to the power adapter and any other network device.
Figure 2-2
shows the rear panel of the VDR-301N.
Rear Panel Port and Button Definition
Connector
POWER
Power on/off button
12V DC
Power connector with 12V DC, 0.5 A
WLAN
WLAN switch -- Press for over 3 seconds to enable or disable the WLAN function.
This button is used for enabling WPS PBC mode.
If WPS is enabled, press this button for over 3 seconds and then the router starts to
WPS
accept the negotiation in the PBC mode.
RESET
Press for more than 3 seconds to reset to factory default setting.
Router is successfully connected to a device through the corresponding port (1, 2, 3,
LAN (1-4)
or 4). If the LED light is flashing, the router is actively sending or receiving data over
that port.
The RJ45 WAN port allows data communication between the router and the network
WAN
through a UTP cable
The RJ11 connector allows data communication between the router and the DSL
DSL
network through a twisted-pair phone wire
Figure 0-2 VDR-301N Rear Panel
Description
18
User Manual of VDR-301N