Force Me Update (J1E2); Password Clear (J1E3); Table 65. Force Me Update Jumper; Table 66. Bios Password Clear Jumper - Intel H2000WP Technical Manual

Configuration Jumpers
position. You should only use this jumper setting when the standard firmware update process
fails. This jumper should remain in the default/disabled position when the server is
running normally.
The server board has several 3-pin jumper blocks that can be used to configure, protect, or
recover specific features of the server board.
8.2

Force ME Update (J1E2)

When this three-pin jumper is set, it manually puts the ME firmware in update mode, which
enables the user to update ME firmware code when necessary.
Jumper Position
1-2
2-3
Note: Normal ME functionality is disabled with the Force ME Update jumper is set to the
enabled position. You should never run the server with the ME Force Update jumper set in this
position. You should only use this jumper setting when the standard firmware update process
fails. This jumper should remain in the default/disabled position when the server is
running normally.
Steps to perform the Force ME Update:
1. Power down and remove the AC power cord.
2. Open the server chassis. For instructions, see your server chassis documentation.
3. Move jumper from the default operating position (covering pins 1 and 2) to the enabled
position (covering pins 2 and 3).
4. Close the server chassis.
5. Reconnect the AC cord and power up the server.
6. Perform the ME firmware update procedure as documented in the README.TXT file
that is included in the given ME firmware update package (same package as BIOS).
7. Power down and remove the AC power cord.
8. Open the server chassis.
9. Move jumper from the enabled position (covering pins 2 and 3) to the disabled position
(covering pins 1 and 2).
10. Close the server chassis.
8.3

Password Clear (J1E3)

This three-pin jumper is used to clear the BIOS password.
Jumper Position
1-2 Normal
2-3 Clear Password
Revision 1.6

Table 65. Force ME Update Jumper

Mode of
Operation
Normal Normal operation
Update ME in force update mode

Table 66. BIOS Password Clear Jumper

Mode of Operation
Normal mode. Password in protection
BIOS password is cleared
Intel order number: G52418-006
®
Intel Server System H2000WP Family TPS
Note
Note
71