Ethernet Connection Procedure - Omron NY Series Hardware User Manual

5 Installation
3
Connect the I/O connector.
Hold the black part
Do not tilt the orange levers
4
Connect an external monitor such as the Industrial Monitor.
Connect the monitor to the DVI connector and tighten the fastening screws or use the optional
NYML connector.
For an Industrial Panel PC this is optional because a monitor is integrated.
5
Connect a device to the optional interface (DVI, RS-232C or NYML) if applicable and tighten
the fastening screws when applicable.
6
Connect the USB ports to peripheral devices .
7
Connect the Box PC to the required Ethernet interface connector(s).
Refer to 5-5-3 Ethernet Connection Procedure on page 5 - 44 for Ethernet port details.
The Box PC is connected.
5-5-3

Ethernet Connection Procedure

Use the following procedure to connect the Ethernet connectors of the IPC Programmable Multi Axis
Controller.
1
Remove the dust caps from the Ethernet ports to be connected.
2
Connect Ethernet Port 1 of the Box PC to the EtherCAT network.
3
Connect Ethernet port 2 of the Box PC to the Modbus-TCP network.
4
Connect Ethernet port 3 of the Box PC to a normal Ethernet network.
The Ethernet connectors are connected.
5 - 44
A when inserting the connector, this enables the auto-locking mechanism.
A
B
B because this will unlock the connector.
NY-series IPC Programmable Multi Axis Controller Hardware User's Manual (W580)