Connect; Connection Procedure - Omron NY Series Manual

4 Installation
4-5

Connect

This section describes how to connect the Industrial Panel PC.
4-5-1

Connection Procedure

Use the following procedure to connect the Industrial Panel PC.
Ensure the Panel PC is securely fastened to the mounting surface.
Ensure the mounted Panel PC can be connected to power and peripheral devices. Remove dust cov-
ers where applicable and store them in a safe place.
Additional Information
• Refer to 4-3 Mount on page 4-4 for mounting details.
• Refer to 2-5 Optional Hardware on page 2-8 for the cables advised by Omron.
Refer to individual cable specifications for cable bending requirements and connector clear-
ance.
Use the following procedure to connect the Panel PC:
1
Ensure the ground terminal is connected.
Refer to 4-4-1 Ground on page 4-10 for grounding details.
2
Connect the Power and I/O connector and tighten the fastening screws.
3
Connect the Serial connecter.
4
Connect the USB ports to peripheral devices .
5
Connect the Panel PC to the Ethernet interface connector(s).
The Panel PC is connected.
4-12
NY-series NYE Industrial Panel PC Conversion Guideline for NS-series products (P157)