Wall Mount Procedure - Omron NY Series Hardware User Manual

5 Installation
• Position the Industrial Box PC with bracket in the mounting location.
• Insert screws through the bracket into the mounting surface.
Note that these screws are not in the scope of delivery.
• Tighten all four screws with a torque of 0.5 N·m.
The Box PC is mounted.
5-3-9

Wall Mount Procedure

Use the following procedure to mount the Box PC in the wall orientation.
Additional Information
• Refer to 5-4-2 Ground on page 5 - 28 for grounding details.
• Refer to 2-10-1 Mounting Brackets on page 2 - 19 for the bracket model.
To mount the Box PC:
1
Mount the Brackets
the brackets.
Tighten these screws with a torque of 0.5 N·m.
2
Mount the Industrial Box PC with the brackets in position.
• Drill the four holes at the location where the Box PC with brackets will be mounted.
Refer to 4-1-8 Bracket Specifications on page 4 - 8 for details.
• Position the Industrial Box PC with bracket in the mounting location.
• Insert screws through the bracket into the mounting surface.
Note that these screws are not in the scope of delivery.
• Tighten all four screws with a torque of 0.5 N·m.
The Box PC is mounted.
5 - 26
A to the Industrial Box PC
B C
A
NY-series IPC Programmable Multi Axis Controller Hardware User's Manual (W580)
C with the 6 Phillips screws B supplied with