Actual Operation And Operation; Battery Replacement; Sd Memory Cards; Usb Flash Drives - Omron NY Series Hardware User Manual

• Do not weld the conductors. Doing so may cause the wires to break with vibration.

Actual Operation and Operation

• After an OS update or a peripheral device driver update for the product is executed, the product be-
havior might be different. Confirm that operation is correct before you start actual operation.
• Always create a Windows System Repair Disk using Windows Backup and Restore to recover the
HDD/SSD configuration if necessary.
• Ensure the fan is operational to provide adequate cooling while the power is turned ON.
• HDD and SSD storage devices, SD Memory Cards, power buttons, fan units and batteries have fi-
nite lives and if those are exceeded, the product may fail or malfunction.
• Always monitor the fan status. If a fan is used beyond its service life, the Low Revolution Speed
warning message is displayed and the product overheating may occur.
• Always monitor the battery warning message. When a battery has low voltage, the system time will
be lost.
• If the product experiences a sudden loss of power or disconnecting the cable while saving a setting
or transfer of data is underway, the changes may not be stored and unexpected behavior may occur.
• Ensure that available software checks are performed by personnel in charge who possess a thor-
ough understanding of the software.
• Do not disconnect the communications cable while the system is running. Doing so may result in a
failure or malfunction of the system.
• Do not reset or power OFF the product while the password is being changed.
• If you fail to save the password there is a possibility that the project will not work.

Battery Replacement

• Turn ON the power after replacing the battery for a product that has been unused for an extended
period of time. Leaving the product unused without turning ON the power even once after the battery
is replaced may result in a shorter battery life.
• Make sure to use a battery of the correct type, install the battery properly.
• Apply power for at least five minutes before changing the battery. Mount a new battery within five
minutes after turning OFF the power supply. If power is not supplied for at least five minutes, the
clock data may be lost. Check the clock data after changing the battery.

SD Memory Cards

• Insert an SD Memory Card completely and ensure it is in place.

USB Flash Drives

• Always use USB memory devices that comply with the USB standards.

Motion Control

• Do not download motion control settings during a Test Run.
NY-series IPC Programmable Multi Axis Controller Hardware User's Manual (W580)
Precautions for Correct Use
21