Figure 3-4 Ospf Authentication Configuration Example - Zte ZXR10 5900E Series Configuration Manual

ZXR10 5900E Series Configuration Guide (IPv4 Routing)
Parameter
<keyid>
md5 <password>
delay <time>
encypt
Configuration Example
Configure the authentication function on OSPF interfaces of S1 and S2, see
Router IDs are listed below.
Device
S1
S2
S3

Figure 3-4 OSPF Authentication Configuration Example

In area 0, establish OSPF neighborhood between S1 and S2. In area 1, establish OSPF
neighborhood between S2 and S3.
Run the following commands on S1:
S1(config)#interface loopback1
S1(config-if-loopback1)#ip adderss 1.1.1.2 255.255.255.255
S1(config-if-loopback1)#exit
S1(config)#interface vlan10
S1(config-if-vlan10)#ip address 30.0.0.1 255.255.255.252
S1(config-if-vlan10)#exit
SJ-20150114102049-003|2015-01-15 (R1.0)
Description
Key ID. Integer type, range: 1-255.
Authentication password. Length: 1-16 characters (without
space).
Time delay (minute). Range: 0-100000.
Used to encrypt the password.
Router ID
1.1.1.2
1.1.1.3
1.1.1.4
3-14
ZTE Proprietary and Confidential
Figure 3-4.