Zte ZXR10 5900E Series Configuration Manual page 52

ZXR10 5900E Series Configuration Guide (IPv4 Routing)
Step Command
2
ZXR10(config-ospfv2)#
[no-redistribution][default-information-originate [metric
<metric-value>][metric-type <type>]][no-summary][
trans-type7-suppress-fa ][ translator-role { always | candidate
}][ translator-stab-intv<stab-intv>]
For a description of the parameters in Step 2, refer to the following table:
Parameters
no-redistribution
default-information-originate
metric <metric-value>
metric-type <type>
no-summary
trans-type7-suppress-fa
translator-role
{ always | candidate }
translator-stab-intv<stab-intv
Configuration Example
Set area 1 to an NSSA area, see
Router IDs are listed below.
Device
S1
S2
S3
SJ-20150114102049-003|2015-01-15 (R1.0)
area <area-id> nssa
Description
NSSA link state advertisements are not redistributed to the
NSSA area.
A default route LSA of type 7 is generated.
Cost for advertising a default LSA of type 7. Value: A 24-bit
integer, ranging from 1 to 16777214.
Type of a default route LSA of type 7: ext-1 and ext-2.
Summary LSAs are forbidden to be sent to the NSSA area.
Suppress address forwarding when LSAs of type 7 are
converted to LSAs of type 5.
Translator role when LSAs of type 7 are converted to LSAs
of type 5.
Two roles are supported: always and candidate.
The duration for keeping a translator role after translator
qualification is lost.
Figure 3-6.
Router ID
1.1.1.2
1.1.1.3
1.1.1.4
3-20
Function
Configures an area to an NSSA
area and specifies whether to
forbid ABR to send summary
route information to the NSSA
area, whether to introduce
external LSAs of type 7 to the
NSSA area, and whether to
generate type 7 default LSAs.
The summary route is not
forbidden by default.
ZTE Proprietary and Confidential