Ospf Configuration Examples; Ospf Configuration Example One; Figure 3-13 Ospf Configuration Example One - Zte ZXR10 5900E Series Configuration Manual

Parameter
LS age
LS Type
Link State ID
Advertising Router
LS Seq Number
Checksum

3.4 OSPF Configuration Examples

3.4.1 OSPF Configuration Example One

Configuration Description
As shown in
loopback address route respectively.

Figure 3-13 OSPF Configuration Example One

Configuration Thought
1. Configure IP addresses of the interconnected interfaces between S1 and S2, and
configure loopback interface IP address.
2. Add interfaces to OSPF area 0.
3. Configure load balancing on both S1 and S2. S1 and S2 can learn the loopback
address route advertised by the peer through two links.
Configuration Process
Configuration on S1:
S1(config)#interface vlan30
S1(config-if-vlan30)#ip address 11.22.1.1 255.255.255.0
S1(config-if-vlan30)#exit
S1(config)#interface vlan40
S1(config-if-vlan40)#ip address 11.22.10.1 255.255.255.0
S1(config-if-vlan40)#exit
S1(config)#interface loopback1
SJ-20150114102049-003|2015-01-15 (R1.0)
Figure 3-13, S1 and S2 set up connection by two links, and advertise their
Description
LSA aging time
LSA type
LS ID
-
LSA sequence number
-
3-45
ZTE Proprietary and Confidential
Chapter 3 OSPF Configuration