Zte ZXR10 5900E Series Configuration Manual page 72

ZXR10 5900E Series Configuration Guide (IPv4 Routing)
Area-filter in not set
Area ranges count 0
For a description of the parameters in the execution result, refer to the following table:
Parameter
OSPF 1 Router ID 100.100.100.14
enable
Domain ID type 0x5,value 0.0.0.1
Number of areas 2, Normal 2, Stub
0, NSSA 0
Area 0.0.0.0 enable (Demand circuit
available) and the following contents
The following is sample output from the show ip ospf interface command:
ZXR10(config)#show ip ospf interface
vlan1 is up
Internet Address 100.100.100.14 255.255.255.0 enable
Up for 00:17:51
In the area 0.0.0.0 DR
Cost 1, Priority 1, Network Type broadcast
Transmit Delay(sec) 1, Authentication Type null
Timer intervals(sec) : Hello 10, Dead 40, Retransmit 5
Designated Router (ID) 100.100.100.14, Interface address 100.100.100.14
Backup Designated router (ID) 100.1.1.2, Interface address 100.100.100.12
Number of Neighbors 1, Number of Adjacent neighbors 1
100.1.1.2
vlan2 is up
Internet Address 1.1.1.1 255.255.255.0 enable
Up for 00:16:25
In the area 0.0.0.1 DR
Cost 1, Priority 1, Network Type broadcast
Transmit Delay(sec) 1, Authentication Type null
Timer intervals(sec) : Hello 10, Dead 40, Retransmit 5
Designated Router (ID) 100.100.100.14, Interface address 1.1.1.1
Backup Designated router (ID) 100.1.1.2, Interface address 1.1.1.10
Number of Neighbors 1, Number of Adjacent neighbors 1
100.1.1.2
For a description of the parameters in the execution result, refer to the following table:
SJ-20150114102049-003|2015-01-15 (R1.0)
OSPF Router with ID (100.100.100.14) (Process ID 1)
BDR
BDR
Description
This OSPF instance is available.
The domain ID type is 0x5, and the value is 0.0.0.1.
There are two areas: two normal areas, 0 stub area, and 0
NSSA area.
Detailed content of each area.
3-40
ZTE Proprietary and Confidential