Zte ZXR10 5900E Series Configuration Manual page 56

ZXR10 5900E Series Configuration Guide (IPv4 Routing)
S2(config)#interface loopback1
S2(config-if-loopback1)#ip adderss 1.1.1.3 255.255.255.255
S2(config-if-loopback1)#exit
S2(config)#interface vlan10
S2(config-if-vlan10)#ip address 30.0.0.1 255.255.255.252
S2(config-if-vlan10)#exit
S2(config)#interface vlan20
S2(config-if-vlan20)#ip address 30.0.1.1 255.255.255.252
S2(config-if-vlan20)#exit
S2(config)#router ospf 1
S2(config-ospf-1)#router-id 1.1.1.3
S2(config-ospf-1)#network 30.0.0.0 0.0.0.3 area 1
S2(config-ospf-1)#network 30.0.1.0 0.0.0.3 area 0
S2(config-ospf-1)#exit
Run the following commands on S3:
S3(config)#interface loopback1
S3(config-if-loopback1)#ip adderss 1.1.1.4 255.255.255.255
S3(config-if-loopback1)#exit
S3(config)#interface vlan10
S3(config-if-vlan10)#ip address 30.0.1.2 255.255.255.252
S3(config-if-vlan10)#exit
S3(config)#router ospf 1
S3(config-ospf-1)#router-id 1.1.1.4
S3(config-ospf-1)#network 30.0.1.0 0.0.0.3 area 0
S3(config-ospf-1)#exit
After the configuration, run the following command to check the routing table. Routes not
aggregated are displayed.
S3#show ip forwarding route
IPv4 Routing Table:
Dest
1.1.1.2
1.1.1.4
2.2.2.0
2.2.2.4
30.0.0.0
30.0.1.0
30.0.1.2
Run the following commands to configure inter-area route aggregation on S2:
S2(config)#router ospf 1
S2(config-ospf-1)#area 1 range 2.2.2.0 255.255.255.248 summary-link
S2(config-ospf-1)#exit
An aggregated route 2.2.2.0/29 is generated in the S3 routing table.
SJ-20150114102049-003|2015-01-15 (R1.0)
Gw Interface
30.0.1.1 vlan10
1.1.1.4 loopback1
30.0.1.1 vlan10
30.0.1.1 vlan10
30.0.1.1 vlan10
30.0.1.2 vlan10
30.0.1.2 vlan10
Owner pri metric
ospf 110 20
address 0 0
ospf 110 20
ospf 110 20
ospf 110 2
direct 0 0
address 0 0
3-24
ZTE Proprietary and Confidential