Zte ZXR10 5900E Series Configuration Manual page 43

Protocol routes:
status codes: *valid, >best, i-internal, s-stale
Dest
*> 1.1.1.4/0
*> 30.0.1.0/32
*> 30.0.1.1/16
If you can ping S1 on S3, the route is configured correctly.
Configuring OSPF Interface Attributes
To set up OSPF neighborhood, perform the following steps to modify the attributes of an
OSPF interface. The attributes need to be consistent with each other if devices provided
by different manufactories need to be interconnected.
Step Command
1
ZXR10(config)#
2
ZXR10(config-ospfv2)#
3
ZXR10(config-ospfv2-if)#
ZXR10(config-ospfv2-if)#
ZXR10(config-ospfv2-if)#
ZXR10(config-ospfv2-if)#
ZXR10(config-ospfv2-if)#
ZXR10(config-ospfv2-if)#
Configuration Example
SJ-20150114102049-003|2015-01-15 (R1.0)
NextHop RoutePrf
192.168.14.2 115
10.10.10.1 0
10.10.10.2 1
router ospf <process-id>[vrf <vrf-name>]
interface <interface-name>
hello-interval <seconds>
dead-interval <seconds>
retransmit-interval <seconds>
transmit-delay <seconds>
cost <cost>
priority <priority>
3-11
Chapter 3 OSPF Configuration
RouteMetric Protocol
20 isis-l2
0 connected
0 static
Function
Enters OSPF configuration
mode.
Enters interface configuration
mode or sub-interface
configuration mode.
Sets the interval (second) for
sending HELLO packets on an
interface.
Range: 1-65535, default: 10.
Sets the duration (second) for
considering a neighbor to be
dead.
Range: 1-65535, default: 40.
Specifies the interval (second)
for retransmitting LSA packets
on an interface.
Range: 1-65535, default: 5.
Specifies the delay (second)
for sending a link state update
packet on an interface.
Range: 1-65535, default: 1.
Sets the interface cost.
Range: 1-65535, default: 100
M/interface bandwidth.
Sets the interface priority.
Range: 0-255, default: 1.
ZTE Proprietary and Confidential