Zte ZXR10 5900E Series Configuration Manual page 132

ZXR10 5900E Series Configuration Guide (IPv4 Routing)
S2(config-if-vlan10)#exit
S2(config)#router bgp 65001
S2(config-bgp)#neighbor 129.213.1.1 remote-as 65000
S2(config-bgp)#exit
View configuration result.
To view the established BGP neighborhood, use show ip bgp neighbor on S1.
S1#show ip bgp neighbor
BGP neighbor is 129.213.1.2, remote AS 65001, external link
......
The IP address of BGP neighbor is 129.213.1.2.
AS65001. EBGP connection is set up already. The router-ID of neighbor is
129.213.1.2 and the state is Established. The session is set up 4 minutes 21
seconds.
To view the established BGP neighborhood, use show ip bgp neighbor on S2.
S2#show ip bgp neighbor
BGP neighbor is 129.213.1.1, remote AS 65000, external link
......
2. Set Up EBGP through Loopback Addresses
As shown in
addresses between S1 and S2.
SJ-20150114102049-003|2015-01-15 (R1.0)
BGP version 4, remote router ID 129.213.1.2
BGP state = Established, up for 00:04:21
hold time is 90 seconds, keepalive interval is 30 seconds
Connections established 1
Local host: 129.213.1.1, Local port: 179
Foreign host: 129.213.1.2, Foreign port: 1024
BGP version 4, remote router ID 129.213.1.1
BGP state = Established, up for 00:00:27
hold time is 90 seconds, keepalive interval is 30 seconds
Connections established 1
Local host: 129.213.1.2, Local port: 1024
Foreign host: 129.213.1.1, Foreign port: 179
Figure 5-4, EBGP neighborhood is set up through loopback
5-8
ZTE Proprietary and Confidential
The neighbor belongs to