Zte ZXR10 5900E Series Configuration Manual page 114

ZXR10 5900E Series Configuration Guide (IPv4 Routing)
Configuration Check
After finishing the configuration above, the following content can be viewed on both S1
and S2. It means that S1 and S2 can set up neighborhood and calculate topology. Ping
the loopback address of the peer on S1 and S2 respectively.
Use show running-config isis on S1 to view whether the IS-IS configuration is correct.
S1(config)#show running-config isis
!
router isis
area 01
system-id 00D0.D0C7.5460
interface vlan10
ip router isis
$
interface loopback1
ip router isis
$
Use show isis adjacency on S1 to view whether the neighborhood is normal. After the
neighborhood is set up, UP will be shown under the field of state.
S1(config)#show isis adjacency
Interface
gei-0/1/1/1
Use show isis topology on S1 to view whether the topology can be calculated correctly. If
the topology is calculated correctly, the following entry can be viewed on the command
output. If "–" is shown under the field of metric, it means the local router. If "**" is shown
under the field of metric, it means inaccessible.
S1(config)#show isis topology
IS-IS paths to Level-1 routers
System id
00D0.D0C7.53E0 10
00D0.D0C7.5460 --
IS-IS paths to Level-2 routers
System id
00D0.D0C7.53E0 10
00D0.D0C7.5460 --
Use show isis circuits on S1 to view the interface information and the DIS election. The
UP means that the interface state is normal. The Down means that the interface state
is abnormal. For abnormal interface state, it is required that inspect the link state and IP
configuration.
S1(config)#show isis circuits
IS-IS interface database:
Interface
SJ-20150114102049-003|2015-01-15 (R1.0)
System id State
00D0.D0C7.53E0 UP/UP
Metric Next-Hop
00D0.D0C7.53E0 vlan10
Metric Next-Hop
00D0.D0C7.53E0 vlan10
State Lev CirId Level1-DR
Lev Holds SNPA(802.2)
L1L2 8/7 0030.3144.5566 64/64
Interface
0030.3144.5566
Interface
0030.3144.5566
Level2-DR
4-30
ZTE Proprietary and Confidential
Pri MT
SNPA
SNPA
Pri(L1/L2)