Zte ZXR10 5900E Series Configuration Manual page 28

ZXR10 5900E Series Configuration Guide (IPv4 Routing)
show Command Output
send subnet only
notify default
originate default
neighbor restrict
This example shows what will be displayed after show ip rip neighbors is used.
ZXR10#show ip rip neighbors
neighbor address
10.1.1.15
Descriptions of command output are shown below.
show Command Output
neighbor address
SJ-20150114102049-003|2015-01-15 (R1.0)
Description
This shows that after this command is used, the interface
only sends the information of the route which belongs to the
same sub network with itself, and it blocks the information of
the route which belongs to other sub network.
It applies to such a case that the lower router sends route
information to upper router. Only the information of local sub
network needs to be advertised. In this way, the route traffic
can be reduced a lot.
The route entry sent by interface contains default route.
For parameter only, that means the route entry sent by
interface only contains default route.
A default route is generated on interface, and it is forced to
advertise.
For parameter only, that means the interface only sends
default route. A default route is generated on interface, and it
is forced to advertise, but the default route is not added into
the routing table of local router but it is added into the routing
table of neighbor router.
Interface neighbor restrict mode
When interface neighbor restrict mode is entered but
neighbor is not configured on the interface, the neighbor
still can be found but no point-to-point packets are sent to
neighbor, and only multicast packets are sent. In this time,
the neighbor can receive the packets. After a neighbor is
configured on the interface, the neighbor which is found
before will be deleted, and no neighbor can be found. At the
same time, the interface only sends point-to-point packets
to the configured neighbor. Meanwhile, the interface can
receive packets from the configured neighbor only, the
packets from other sources are discarded.
To realize the effect described above, neighbor restrict mode
has to be configured on both of routers, and the routers need
to enable neighbor.
interface
vlan2
Description
IP address identifier of RIP neighbor
2-12
ZTE Proprietary and Confidential