Zte ZXR10 5900E Series Configuration Manual page 150

ZXR10 5900E Series Configuration Guide (IPv4 Routing)
Step
1
2
3
Descriptions of the parameters used by step 1 are shown below.
Parameter
<map-tag>
permit
deny
<sequence-number>
Descriptions of the parameters used by step 2 are shown below.
Parameter
<acl-name>
<rule-no >
permit
deny
<source>
<source-wildcard>
any
Descriptions of the parameters used by step 3 are shown below.
Parameter
<ipv4-address>
SJ-20150114102049-003|2015-01-15 (R1.0)
Command
route-map <map-tag>[permit |
ZXR10(config)#
deny][<sequence-number>]
ipv4-access-list { name <acl-name>}
ZXR10(config)#
ZXR10(config-ipv4-acl)#
deny}{<source>[<source-wildcard>]| any}
router bgp <as-number>
ZXR10(config)#
neighbor [<ipv4-address>|<peer-gr
ZXR10(config-bgp)#
oup-name>] route-map <map-tag>{in | out}
rule <rule-no >{permit |
Description
Name of route mapping, the length is 1-31 characters.
Permits redistribution or policy routing tag if the route map
meets the matching condition
Denies redistribution or policy routing tag if the route map
meets the matching condition
Sequence No. in the range of 0-65535
Description
Standard ACL list name, the length is 1-31 characters.
ACL rule range: 1-2147483644.
Permit the packets matching with the rule to pass
Deny the packets matching with the rule to pass
Source IP address
Wild mask of source IP address
Any source IP address
Description
IPv4 address of neighbor, in dotted decimal notation
5-26
ZTE Proprietary and Confidential
Function
This defines a route map.
This configures serial number,
name or alias to an ACL in
standard ACL configuration
mode.
This defines the rule of
standard ACL.
This starts BGP process
and specifies AS number of
router.
This defines a route map.