McQuay WSC Operating Manual page 21

Figure 7, Expanded Power View Screen
This View Menu is accessed by
pressing the MENU button from
the Detail View Screen.
menu screen is used to access
other screens containing various
data. A screen with unit
temperatures and pressures is
shown on a BAR CHART
SCREEN (see Figure 12 on page
23). This screen is accessed by
pressing LABELED
GRAPHS. Pressing
GRAPHS will access the same
screen, but without the labels
There is more data available to
view and it is accessed through
the buttons on the right of the
screen. It is segregated by
general topics that are self-
explanatory. These buttons are also repeated on the Detail View Screen as previously noted. If the starter
display option has been included, a POWER button will be located above the STATE button.
OM Centrif Micro ΙΙ-5
Pressing the EVAP or COND button will give detailed information on the
evaporator or condenser pressures and temperatures.
Pressing the MENU button on the bottom of the screen will go to a menu
(see Figure 8) from which the above listed screens can also be accessed.
Pressing the POWER button will access a screen showing power data for
the unit. The ability to view the unit's electrical performance and to set
starter setpoints on the interface screen is an optional extra available at
the time of purchase. If the option is supplied on the unit, a "POWER"
button will be visible on the upper left side of the VIEW screen. Pressing
the button will open the screen shown in Figure 7.
The screen shown to the right will be superimposed on the right
side of the VIEW screen shown in Figure 6 when the optional
"Full Meter Display" is included with the unit. This screen will
remain visible until another display button; such as STATE, I/O,
etc is pressed.
If this option is not included, Percent Unit RLA on the HOME
VIEW screen displays the current percent of the unit rated loads
amps.
Figure 8, View Menu
The
BAR
BAR
21