Table of Contents
Advertisement
A program "runs" in either mode, but can only be downloaded and debugged when the
RCM3209/RCM3229 is in the Program Mode.
Refer to the
Rabbit 3000 Microprocessor User's Manual
gramming port.
4.3.2 Standalone Operation of the RCM3209/RCM3229
The RCM3209/RCM3229 must be programmed via the Prototyping Board or via a similar
arrangement on a customer-supplied board. Once the RCM3209/RCM3229 has been pro-
grammed successfully, remove the serial programming cable from the programming con-
nector and reset the RCM3209/RCM3229. The RCM3209/RCM3229 may be reset by
cycling the power off/on or by pressing the
RCM3209/RCM3229 module may now be removed from the Prototyping Board for end-
use installation.
CAUTION: Disconnect power to the Prototyping Board or other boards when removing
or installing your RCM3209/RCM3229 module to protect against inadvertent shorts
across the pins or damage to the RCM3209/RCM3229 if the pins are not plugged in
correctly. Do not reapply power until you have verified that the RCM3209/RCM3229
module is plugged in correctly.
30
for more information on the pro-
button on the Prototyping Board. The
RESET
RabbitCore RCM3209/RCM3229
Advertisement
Table of Contents
Need help?
Do you have a question about the RabbitCore RCM3209 and is the answer not in the manual?
Questions and answers