Standalone Operation Of The Rcm4200 - Rabbit RabbitCore RCM4200 User Manual

C-programmable analog core module with serial flash and etherne

Table of Contents

A program "runs" in either mode, but can only be downloaded and debugged when the

RCM4200 is in the Program Mode.

Refer to the

Rabbit 4000 Microprocessor User's Manual

gramming port.

4.3.2 Standalone Operation of the RCM4200

Once the RCM4200 has been programmed successfully, remove the programming cable

from the programming connector and reset the RCM4200. The RCM4200 may be reset by

cycling, the power off/on or by pressing the

RCM4200 module may now be removed from the Prototyping Board for end-use installa-

tion.

CAUTION: Power to the Prototyping Board or other boards should be disconnected

when removing or installing your RCM4200 module to protect against inadvertent

shorts across the pins or damage to the RCM4200 if the pins are not plugged in cor-

rectly. Do not reapply power until you have verified that the RCM4200 module is

plugged in correctly.

for more information on the pro-

button on the Prototyping Board. The

RESET

RabbitCore RCM4200

Table of Contents