How To Set Ip Addresses In The Sample Programs - Rabbit RabbitCore User Manual

6.4.1 How to Set IP Addresses in the Sample Programs

With the introduction of Dynamic C 7.30 we have taken steps to make it easier to run
many of our sample programs. You will see a
Dynamic C to select your configuration from a list of default configurations. You will
have three choices when you encounter a sample program with the
1. You can replace the
,
MASK MY_GATEWAY
2. You can leave
TCPCONFIG
to , the netmask to
10.10.6.100
to . If you would like to change the default values, for example, to use an IP
10.10.6.1
address of
10.1.1.2
edit the values in the section that directly follows the "General Configuration" com-
ment in the
TCP_CONFIG.LIB
directory.
3. You can create a
CUSTOM_CONFIG.LIB
than 100. Instructions for doing this are at the beginning of the
library in the
LIB\TCPIP
There are some other "standard" configurations for
features such as DHCP. Their values are documented at the top of the
library in the
LIB\TCPIP
IP User's Manual.
68
macro with individual
TCPCONFIG
, and
MY_NAMESERVER
at the usual default of 1, which will set the IP configurations
255.255.255.0
for the RCM3750 module, and
library. You will find this library in the
directory.
directory. More information is available in the Dynamic C TCP/
macro. This macro tells
TCPCONFIG
MY_IP_ADDRESS
macros in each program.
, and the nameserver and gateway
10.1.1.1
library and use a
TCPCONFIG
that let you select different
TCPCONFIG
macro.
TCPCONFIG
,
MY_NET-
for your PC, you can
LIB\TCPIP
value greater
TCP_CONFIG.LIB
TCP_CONFIG.LIB
RabbitCore RCM3750